Common Frame Drive Belt Replacement - Precor Experience 700 Series Service Manual

TIP: Use (turn) the Drive Motor flywheel to make it easier to turn the motor pulley
and help walk the belt onto or off the Drive Motor and Drive Roller pulleys.
4. Reinstall the left side Dust Guard #3 Phillips fastener and fully tighten.
5. Make sure the Drive Belt pulley alignment is correct and verify that the belt tension is
within specification. see
page 58. If the belt is not within specification, tension to specification.
6. Connect the power cord and switch the power ON.
7. Operate the treadmill and verify the running belt tracking, see
and Tracking Adjustment" on
8. Reinstall the left and right trim landing covers, see
ment" on page 91.
9. Reinstall the hood cover, see
10. Do the Operation Verification tests (see
return to service.

Common Frame Drive Belt Replacement

Review entire procedure before starting.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Legacy Frame Drive Belt Tension and Alignment" on
page 67.
"Covers and Panels Replacement" on
"Operation Verification" on
6 Replacement Procedures
Drive Belt Replacement
"Running Belt Tension
"Trim Landing Covers Replace-
page 86.
page 24) and
Page 149