Precor Experience 700 Series Service Manual page 158

2. Center and square the running belt on the Drive and Take-up Rollers. Tension the run-
ning belt to specification, see
page 67. DO NOT apply power or verify belt tracking at this step in the process, the
running belt tracking will be verified after the Drive Belt is installed.
3. Install the drive belt. Place the Drive Belt onto the drive pulley and then walk the belt
onto the Drive Motor pulley.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Running Belt Tension and Tracking Adjustment" on
6 Replacement Procedures
Drive Belt Replacement
Page 148