Precor Experience 700 Series Service Manual page 109

ID
Removal Instructions
Repeat procedure for both the left and right end cap covers.
1. Remove the hood cover, see
2. Remove the left and right trim landing covers, see
3. Remove the two #3 Phillips trim end cap cover fastener screws. One screw on the top
and one screw on the back of the cover. Then slide the cover rearward to remove.
(missing or bad snippet)
TIP: Use a short stub #3 Phillips screwdriver to remove the bottom end cap fastener.
4. Repeat the same removal procedure to remove both the left or right trim end cap cov-
ers.
Installation Instructions
Repeat procedure for both the left and right covers.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Description
Trim End Cap - left
Trim End Cap - right
"Hood Cover Replacement" on
6 Replacement Procedures
Covers and Panels Replacement
page 88.
Trim Landing Cover Replacement.
Page 99