Precor Experience 700 Series Service Manual page 220

11. If the MC was loosened or removed, install the MC and secure fasteners, see
Controller (MC) Replacement" on
Remove blocking and lower treadmill
Note: If you used the side access method, then refer to the "Side lift motor
jackscrew access" procedure to upright the treadmill, see
page 82.
12. .Connect the power cord and switch the power ON. Be aware that switching the
power ON will cause the incline platform to move and return to the level "0" position.
WARNING: Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
13. Access the service menu (51765761) and select the INCLINE TEST. Increase the
incline level enough to lift the treadmill frame off the supports.
14. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
15. Lower the incline to level "0".
Operation Verification
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
page 123.
6 Replacement Procedures
Lift Motor Replacement
"Motor
"Side access" on
Page 210