Precor Experience 700 Series Service Manual page 193

4. Use the 5/16" hex key socket and ratchet to alternately hand tighten the running belt
tension adjustment bolts until snug and stop.
5. Tension the running belt to specification and verify alignment and tracking, see
ning Belt Tension and Tracking Adjustment" on
6. Reinstall the left and right Landing Trim covers, see
ment" on page 86
page 86,.
7. Do the Operation Verification tests (see
return to service.
Legacy Frame with "Common Take-up Roller" Installation
Legacy Frame - "Common Take-up Roller" Installation
Use this procedure to install the common frame take-up roller onto a legacy frame
weldment.
Review entire procedure before starting.
1. Clean the running belt, deck, and Take-up roller.
2. Install the Take-up roller through the running belt:
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
and hood cover, see
page 67.
"Covers and Panels Replace-
"Covers and Panels Replacement" on
"Operation Verification" on
6 Replacement Procedures
Take-up Roller Replacement
"Run-
page 24) and
Page 183