Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
left/right Trim Landing covers, see
3. Remove the Take-up Roller, see
4. Remove the Drive Roller, see
5. Remove the four 5/32" hex key bolt and washer rear deck fasteners. These fasteners
attach to the left and right rear deck pivot assemblies. The 1/2" fastener nuts are
press fit into the bottom of the deck pivot housing, be aware that the nuts can fall from
the housing as the bolts are being removed. If this happens, reinsert the nut into the
pivot housing. Retain part(s) and/or fastener(s) for installation.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Running Belt and Deck Replacement Procedure
1
unplug
the power cord.
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
"Take-up Roller Replacement" on
"Drive Roller Replacement" on
6 Replacement Procedures
page 86, and
page 86.
page 178.
page 168.
Page 189