Specification; Procedure - Precor Experience 700 Series Service Manual

Specification

Ammeraal Beltech brand running belt tension (PPP000000303765103)
(2)
Forbo brand running belt tension (PPP000000302449101 or
PPP000000036355141)
Notes:
1. Referenced to gauge reading 3.0 (0.0%)
2. The Ammeraal Beltech brand running belt must NOT be used with a pre-waxed deck.
3. The Forbo brand running belt must be used with a pre-waxed deck.

Procedure

CAUTION:
Running belt tension adjustment
CAUTION:
Review entire procedure before starting.
1. Clean the running belt and deck, see
on page 280.
2. Switch the power OFF and
3. Remove the front hood, see
4. Remove the left and right trim landing covers, see
on page 86.
5. Legacy frame configuration:
Make sure that the left and right front Drive Roller Keeper(s) are installed.
Note: Some early production treadmills may only have one or no Roller keepers
installed. Install missing Roller Keepers as needed( PPP000000302495102 RIGHT
HAND ROLLER KEEPER, PPP000000302495102 LEFT HAND ROLLER
KEEPER).
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
System Component
(3)
1) The tracking adjustments should only be done in 1/4 turn incre-
ments.
2) ONLY use the right side tension bolt to adjust tracking.
3) ONLY use hand tools to adjust tracking.
1) ONLY use hand tools for belt tension adjustment.
2) Final belt tension adjustments should only be done in 1/4 turn incre-
ments.
1
unplug
"Covers and Panels Replacement" on
Running Belt Tension and Tracking Adjustment
"Running Belt and Deck Cleaning Procedure"
the power cord.
"Covers and Panels Replacement"
5 Adjustment Procedures
Specification
(1)
3.75 (0.75%)
(1)
3.55 (0.55%)
page 86.
Page 68