Common Frame Drive Belt Tension And Alignment - Precor Experience 700 Series Service Manual

motor pulley mechanism.
6. Re-tighten the four motor mount fasteners and torque to specification 204 in-lbs (17
ft-lbs, 23 N-m).
7. Reinstall drive belt. Place drive belt onto the motor pulley and walk the belt onto the
drive roller pulley. Use one hand to move the motor flywheel which rotates the motor
pulley and the other hand to walk the belt onto the drive roller pulley.
8. Place the tension gauge onto the belt and remeasure the tension.
a. If the tension measurement is not within specification, repeat the tension adjust-
ment process until the measured tension is within the drive belt tension spe-
cification.
Belt Condition
New
Used
9. Connect the power cord and switch the input power ON.
10. Run the treadmill speed at 3 mph (5 kph) for 1 minute.
11. Switch the input power OFF and unplug the power cord.
12. Repeat the belt tension measurement and verify that the tension remains within the
drive belt tension specification. If not within specification, repeat the drive belt tension
adjustment procedure until the drive belt is within specification.
Belt Condition
New
Used
13. Verify that the drive belt alignment has not moved out of alignment during the belt ten-
sioning process,, see
Operation verification
14. Reinstall the hood cover, see
15. Connect the power cord and switch the input power ON.
16. Do the Operation Verification tests (see
return to service.
Common Frame Drive Belt Tension and Alignment
Review entire procedure before starting.
Drive belt alignment
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Drive Belt Tension
100-120 lbs (45-54 kgs)
80-90 lbs (36-41 kgs)
Drive Belt Tension
100-120 lbs (45-54 kgs)
80-90 lbs (36-41 kgs)
"Drive belt alignment" on
"Hood Cover Replacement" on
"Operation Verification" on
5 Adjustment Procedures
Drive Belt Tension and Alignment Adjustment
page 58.
page 88.
page 24) and
Page 61