Procedure; Legacy Frame Drive Motor Replacement; Motor Controller (Mc) Replacement" On Page - Precor Experience 700 Series Service Manual

Procedure

There is a replacement procedure for the legacy frame and common frame configurations.
Legacy Frame, see
l
Common Frame, see
l

Legacy Frame Drive Motor Replacement

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
3. Disconnect the Motor Controller "MTH" and "MOTOR" electrical connections:
a. Remove the
see "Motor Controller (MC) Replacement" on
b. Disconnect the MC "MTH" and "MOTOR" interface cable connectors, see
"Motor Controller (MC) Replacement" on
c. Remove the MOTOR power cable from the three frame cable clamps.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
2
Motor controller, motor controller unit, or motor controller module: used on treadmills, con-
tains the LPCA and motor controller functionality.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Legacy Frame Drive Motor Replacement" below
"Common Frame Drive Motor Replacement" on page 160
1
unplug the power cord.
"Hood Cover Replacement" on
2
MC base from the mounting fasteners to allow connector access,
6 Replacement Procedures
Drive Motor Replacement
page 88.
page 123.
page 123.
Page 155