Precor Experience 700 Series Service Manual page 162

Installation Instructions
1. Lift the drive roller from the frame mounting brackets enough to install the belt onto
the drive roller pulley. Reinstall the drive roller into the frame mounting brackets.
2. Square the running belt on the drive and take-up rollers and tension the running belt
to specification, see
DO NOT apply power or verify the running belt tracking at this step in the process, the
running belt tracking will be verified after the Drive Belt is installed.
IMPORTANT: It is necessary to tension the running belt prior to tensioning the drive
belt.
3. Install the drive belt onto the drive motor pulley (walk the belt onto the drive motor pul-
ley).
4. Make sure the drive belt is properly aligned by verifying that the drive belt is parallel to
the left frame rail. Measure the drive belt-to-frame rail distance at the drive roller pul-
ley and at the drive motor pulley. The drive belt is correctly aligned when the two
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Running Belt Tension and Tracking Adjustment" on
6 Replacement Procedures
Drive Belt Replacement
page 67.
Page 152