Creating A Basic 5G Nr Signal Using Pathwave N7631Appc Embedded Software - Keysight M9383B Measurement Manual

5G NR Measurements Using the VSA Software
5G Waveform and EVM Analysis Using VSA Software
Creating a Basic 5G NR Signal Using PathWave N7631APPC
Embedded Software
PathWave software tools can be used to create, download, and playback
waveforms through the VXG.
This example shows you how to create and analyze a 5G NR signal using the
embedded PathWave software. Your VXG must include the N7631APPC
license.
Using the graphical user interface
On the VXG:
1. Select Preset to set the VXG to a known state.
2. In the Output area, set Frequency to 28 GHz and Power to 
3. Select the Signal block to open the Vector Modulation Signal Setup panel.
4. Set Vector Modulation Signal Mode to 5G NR, then Edit Signal.
116
-10 dBm.
M9383B/84B Measurement Guide