Keysight M9383B Measurement Manual page 85

5G New Radio (NR) Measurements using X-Apps
5G Waveform, EVM, and ACP Analysis Using X-Applications
A power amplifier customer typically uses the same waveform at different
TIP
frequencies and they will not want to generate a separate waveform for each
frequency. In this case, you would turn Phase Compensation Off, so the
waveform becomes independent from the carrier frequency. You need to do
the same on the analysis side, or the demod will fail.
5. Select the Carriers tab and then select Edit.
6. Select the Full-Filled Config tab and set Bandwidth to 
If you have hardware that is wide enough to cover the other FR2
bandwidths, 200 MHz or 400 MHz, you can choose to use a wider
bandwidth.
M9383B/84B Measurement Guide
FR2 100 MHz, Numerology to
Full Filled Configurations is a great place to start creating your waveform.
You can select FR, bandwidth, and modulation format with a fully
allocated PDSCH data channel. This would represent a spectrally correct
signal a typical power amplifier would use. You can modify the RB
allocations and Slot allocations if fully allocated data channels are not
desired.

120 kHz and then select OK.
85