Keysight M9383B Measurement Manual page 108

5G NR Measurements Using the VSA Software
5G Waveform and EVM Analysis Using VSA Software
11.For two channel instruments only: In the top right corner of the display,
The state of RF Out (All) does not change the RF Out state of a specific
channel. For example, if RF Out for Channel 1 is set to on and RF Out (All)
is set to off, no power is emitted from the RF Output connector of Channel
1. Likewise, if RF Out for Channel 1 is set to off and RF Out (All) is set to on,
no power is emitted from the RF Output connector of Channel 1.
On the N9040B:
— Open the VSA software by selecting Mode Meas > Launch VSA.
If accessing the instrument via a Remote Desktop connection, select the
Screen tab (at the top of the display) to open the
Mode/Measurement/View Selector window.
In the VSA software:
1. From the menu bar, select File > Preset > All to set the VSA to a known
All example waveforms and setup files are located on the VXG at:

D:\Users\Instrument\Documents\Keysight\PathWave
\SignalGenerator\Examples

You will need to copy over the setup files to the N9040B or the PC running
the VSA application.
2. Select File > Recall > Recall Setup and navigate to
3. From the toolbar, select the Pause Icon.
4. From the menu bar, select Input > Trigger and set Style to External and
108
set RF Out (All) to On by selecting the switch.
state.
D:Users\Instrument\MyDocuments\NR5G\data\NR5GEvm\Carrier Setup,
then open
5GNR_8CC_FR2_120kHz_SCS_100MHz_256QAM_Corrected_
28GHz.setx
Pausing the measurement will help to speed up the setup time.
Level to 1.0 V.
M9383B/84B Measurement Guide