Keysight M9383B Measurement Manual page 51

Basic Measurements
Making Measurements
Adding fixture blocks using s2P files
On the VXG:
SYSTem:PRESet
RF1:FREQuency:CW 10GHZ
RF1:POWer:AMPLitude -20dBm
SIGNal1:MODE MTONe
SIGNal1:MTONe:ARB:NTONe 21
SIGNal1:MTONe:ARB:FSP 100MHZ
SIGNal1 ON
RF1:OUTPut:STATe ON
For multi-channel instruments, set RF Out (all) to On.
RFALl:OUTPut ON
On the N9040B:
SYSTem:PRESet
FREQuency:CENTer 10GHZ
FREQuency:SPAN 3GHZ
On the VXG:
Set the path to the s2p data as block 2 (you can use 1 through 4).
CORRection:BLOCk2:FILE "FixtureChannel2"
CORRection:BLOCk2 ON
Add block C with the same file.
CORRection:BLOCk3:FILE "FixtureChannel2"
Change Block C to Embed.
CORRection:BLOCk3:APPLy EMBedding
CORRection:BLOCk3 ON
M9383B/84B Measurement Guide 51