Basic Measurements
Making Measurements
4. For two channel instruments only: In the top right corner of the display,
The state of RF Out (All) does not change the RF Out state of a specific
channel. For example, if RF Out for Channel 1 is set to on and RF Out (All)
is set to off, no power is emitted from the RF Output connector of Channel
1. Likewise, if RF Out for Channel 1 is set to off and RF Out (All) is set to on,
no power is emitted from the RF Output connector of Channel 1.
On the N9040B:
1. Select Frequency and set Center Frequency to 1 GHz and Span to
2. Select Peak Search.
On the VXG:
1. Set Output 1 Power to –90 dBm.
2. Ensure that RF Out is On.
M9383B/84B Measurement Guide
set RF Out (All) to On by selecting the switch.
1 MHz.
Observe the accuracy of the amplitude and frequency of the signal.
11