5G NR Measurements Using the VSA Software
5G Waveform and EVM Analysis Using VSA Software
9. Select the BWP pane, then enable DL-BWP.
126
This section is used to configure the Downlink BWP allocation within the
component carrier and the control resource set (CORESET). CORESET is
used for PDCCH configuration and will not be used in this example. We
will use the default values of:
— Numerology
— RB offset 0 RB
— RB Number 66 RB
A component carrier with 100 MHz at FR2 has a maximum RB of 66
for 120 kHz numerology. In this example, DL-BWP uses the full
carrier bandwidth of 66 RBs as shown below.
120 kHz
M9383B/84B Measurement Guide