Keysight M9383B Measurement Manual page 90

5G New Radio (NR) Measurements using X-Apps
5G Waveform, EVM, and ACP Analysis Using X-Applications
2. In the System Configuration setup, click on the Remote Signal Analyzer
3. Set Connection Type to LAN.
4. In the Connect Remote X-Series Signal Analyzer setup, enter the
5. Under Set Protocol, select HiSLIP and use the Remote name hislip0.
6. Select Test Connection to verify, then select OK.
7. Select Auto Configure Analyzer to send the VXG settings to the analyzer.
90
block (on far right) to setup the communication channel to the Keysight
X-Series Signal Analyzer.
Hostname or IP Address for the signal analyzer.
M9383B/84B Measurement Guide