Attach Elbow Assemblies And Tnr2 Slide Support - KidKraft F24930 Installation And Operating Instructions Manual

Step 34: Attach Elbow Assemblies and TNR2 Slide Support
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose until
further step.
A: Attach the two remaining Elbow Assemblies as instructed in Steps 31 and 32 .
B: Place TNR Brace Assembly against (2618) Front Back Panel so it sits under the slide . It is not attached yet .
(fig. 34.1)
C: On the fourth Elbow Assembly attached remove the pan bolt and nut which is facing the fort (installed in Step
29). (fig. 34.1) The bolt will no longer be needed, but keep the lock nut.
D: Loosely attach TNR3 Tube Support (at the slightly bent end) to the Clamp Ring using 1 (PB6) 1/4 x 1" Pan
Bolt (with flat washer and the previously removed lock nut). (fig. 34.2)
E: Rotate TNR3 Tube Support and attach to (2622) End Panel Assembly using 1 (S6) #12 x 1" Pan Screw as
shown in fig. 34.2.
F: Fully tighten screw and bolt .
Fig. 34.2
TNR 3 Tube
Support
2622
Note: Flat
end down
Remove PB1 (1/4 x 3/4"
Pan Bolt) first then install
PB6 (1/4 x 1" Pan Bolt
with flat washer)
Lock
Nut
Flat
Washer
PB6
S6
1 x #12 x 1" Pan Screw
S6
1 x 1/4 x 1" Pan Bolt
PB6
(1/4" flat washer & 1/4" lock nut - previously removed)
16 x 1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
2618
TNR Brace
Assembly
Hardware
74
Fig. 34.1
Attach 2
remaining
Elbow
Assemblies
Other Parts
1 x TNR3 Tube Support
4 x TNR2 Slide Clamp Ring