Attach Elbow Assemblies And Tnr2 Slide Support - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 35: Attach Elbow Assemblies and TNR2 Slide
Support
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the round
recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose until
further step.
A: Attach the two remaining Elbow Assemblies as instructed in Steps 32 and 33.
B: Place TNR Brace Assembly against (2771) End Post Left so it sits under the slide. It is not attached yet.
(fig. 35.1)
C: On the fourth Elbow Assembly attached remove the pan bolt and nut which is facing the fort (installed in Step
30). (fig. 35.1) The bolt will no longer be needed, but keep the lock nut.
D: Loosely attach TNR3 Tube Support (at the slightly bent end) to the Clamp Ring using 1 (PB6) Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 35.2)
E: Rotate TNR3 Tube Support and attach to (2771) End Post Left using 1 (S6) Pan Screw as shown in fig. 35.2.
F: Fully tighten screw and bolt.
Fig. 35.2
TNR 3 Tube
Support
2771
Note: Flat
end down
Remove PB1 (Pan Bolt)
first then install PB6 Pan
Bolt with flat washer)
LN1
FW1
PB6
S6
1 x
S6
1 x
PB6
16 x
PB1
2771
TNR Brace
Assembly
Hardware
Pan Screw
Pan Bolt (flat washer & lock nut - previously removed)
Pan Bolt (lock nut)
73
Fig. 35.1
Attach 2
remaining
Elbow
Assemblies
Other Parts
1 x TNR3 Tube Support
4 x TNR2 Slide Clamp Ring