Swing Beam Assembly - KidKraft F24145 Installation And Operating Instructions Manual

Step 1: Swing Beam Assembly
Hex Bolt Assembly
Lock
Washer
Flat He x
Washer Bolt
A: In the middle holes of (1772) CE
SW Beam Back install 2 Bolt Thru
Swing Hangers making sure the
swing hangers are oriented in the
direction shown in fig. 1.3 to maintain
proper swing motion.
B: In the end holes of (1773) CE SW
Beam Front install 2 Bolt-Thru Swing
Hangers making sure the swing
hangers are oriented in the direction
shown in fig. 1.3 to maintain proper
swing motion.
C: Attach 1 (H7) 1/4 x 5-1/2" Hex
Bolt (with lock washer, flat washer
and t-nut) to the ends of each (1772)
CE SW Beam Back and (1773) CE
SW Beam Front. The bolts do not
attach to anything, but MUST be in-
stalled to the beams to prevent split-
ting and checking of wood. (fig. 1.1)
D: Attach 1 Triangle Plate to each end of both the (1773) CE SW Beam Front and (1772) CE SW Beam Back using
1 (G1) 5/16 x 1-1/2" Hex Bolt (with lock washer, flat washer and t-nut) per Triangle Plate in the hole indicated in fig.
1.2. Correct hole usage is very important. Refer to fig 1.2 for correct placement of Hex Bolts.
Important!
Swing End
(With Overhang)
Wood Parts
1 x CE SW Beam Front 2 x 6 x 69-1/2"
1773
1 x CE SW Beam Back 2 x 6 x 69-1/2"
1772
T- Nut
Fig. 1.2
x 4
G1
4 x 5/16 x 1-1/2" Hex Bolt
G1
(5/16" lock washer, 5/16" flat washer and 5/16" t-nut)
4 x 1/4 x 5-1/2" Hex Bolt
H7
(1/4" lock washer, 1/4" flat washer and 1/4" t-nut)
Fig. 1.3
Make sure triangle is
tight against beam
Bolt Thru Hangers
1772
Back
Back
1772
Triangle Plates
Front
1773
Hardware
14
Warning: For your childs safety,
orientate the swing hangers as
shown to ensure your swing will
have proper swing motion when
installed. Failure to do so could
result in premature failure of the
swing hanger or swing chain.
Fig. 1.1
Front
1773
Important!
Fort End Side
(No Overhang)
Other Parts
4 x Bolt Thru Swing Hangers
1 x Triangle Plates (pkg of 4)
H7
x 4