Swing Beam Assembly - KidKraft TREASURE COVE Installation And Operating Instructions Manual

Step 6: Swing Beam Assembly
A: Attach 6 Swing Hangers to the (2614) Engineered Beam using 2 (G7) 5/16 x 5-1/2" Hex Bolts (with 2 flat
washers and 1 lock nut) per Swing Hanger as shown in fig. 6.1.
B: Flush to the Fort End of (2614) Engineered Beam attach 2 L-Beam Brackets with 2 (G21) 5/16 x 3-3/4" Hex
Bolts (with 2 flat washers and 1 lock nut). (fig. 6.1 and 6.2)
C: Install 1 (WB7) 5/16 x 3" Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (2614) Engineered
Beam as shown in fig. 6.3. IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE
CHECKING OF WOOD.
Fort End
Fig. 6.2
Fort End
L-Beam
Bracket
Flush
L-Beam
Bracket
Wood Parts
1 x Engineered Beam 4 x 6 x 88"
2614
Swing Hanger x 6
G7
LN2
2614
FW2
FW2
X
X
G21
12 x G7 5/16 x 5-1/2" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
2 x 5/16 x 3-3/4" Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
G21
1 x 5/16 x 3" Wafer Bolt (5/16" flat washer & 5/16" t-nut)
WB7
Fig. 6.1
Fig. 6.3
Hardware
29
2614
TN2
FW2
Other Parts
6 x Swing Hangers
2 x L-Beam Bracket
LN2
Swing End
FW2
2614
WB7