Swing Beam Assembly; Hex Bolt (Lock Washer, Flat Washer And 1 T-Nut) - KidKraft CASTLEWOOD Installation And Operating Instructions Manual

Step 6: Swing Beam Assembly
A: Attach 6 Swing Hangers to (2614) Engineered Beam using 2 (G7) Hex Bolts (with 2 flat washers and 1 lock
nut) per Swing Hanger, as shown in fig. 6.1.
B: Flush to the Fort End of (2614) Engineered Beam attach 2 L-Beam Brackets with 2 (G21) Hex Bolts (with 2
flat washers and 1 lock nut). (fig. 6.2)
C: Install 1 (WB7) Wafer Bolt (with flat washer and t-nut) in the middle bolt hole in (2614) Engineered Beam as
shown in fig. 6.3. IT IS IMPORTANT THAT THIS BOLT IS ATTACHED. IT WILL MINIMIZE CHECKING OF
WOOD.
D: Attach Cedar Summit by KK Plaque to centre of (2614) Engineered Beam (over top of t-nut) using 4 (S18)
#6 x 1" Wood Screws. (fig. 6.4)
Fig. 6.1
Fort End
Fig. 6.2
5/16"
Lock Nut
Fort End
L-Beam
Bracket
Flush
L-Beam
Bracket
Wood Parts
1 x Engineered Beam 4 x 6 x 88"
2614
Swing Hanger x 6
2614
5/16" Flat
Washer
5/16" Flat
Washer
G21
12 x G7 Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
2 x Hex Bolt (5/16" flat washer x 2, 5/16" lock nut)
G21
1 x Wafer Bolt (5/16" flat washer & 5/16" t-nut)
WB7
4 x #6 x 1" Wood Screw
S18
Fig. 6.3
5/16"
T-Nut
5/16" Flat
Washer
WB7
Hardware
34
2614
G7
Fig. 6.4
2614
Cedar Summit
Plaque
Other Parts
6 x Swing Hangers
2 x L-Beam Bracket
1 x Cedar Summit
by KK Plaque
5/16"
Lock Nut
5/16" Flat
Washer
S18
x 4