Table of Contents
Advertisement
7.12 Adjusting the Tool Checking Position (FC4500-50 / 60 only)
Perform this adjustment when the Main Board was replaced.
Confirm the Pen Sense Rubber is put to the correct position if the Pen Sense Rubber was replaced (See
section 6.48.).
Prepare the two water-based fiber-tip pens.
How to adjust the Tool Checking Position
(1) Turn off the power if the power is on.
(2) Set the DIP switch to adjustment mode.
(3) Turn on the power.
(4) Press the [Next Page] key until the following menu is displayed.
(5) Press the [Enter] key to display the following menu.
Each keys are corresponding to the following operations.
F1: Cursor moves to the 1st pen of X position adjustment menu.
F2: Cursor moves to the 1st pen of Y position adjustment menu.
F3: Cursor moves to the 2nd pen of X position adjustment menu.
F4: Cursor moves to the 2nd pen of Y position adjustment menu.
Position Keys: Adjustment value and position of digit can be changed.
TEST key: Selects the 1st pen, and then it moves to the checking position for the 1st tool. And when
the TEST key pressed again, then it selects the 2nd pen, and then it moves to the checking position
for the 2nd pen.
(6) Attach the pens to the 1st pen holder and the 2nd pen station.
(7) Press the [TEST] key, it moves to the checking position with 1st pen.
FC4500-UM-251-9370
1
2 3 4 5 6 7 8
FORCE
F1
SET CARCHK POS
PRESS ENTER KEY!!
F2
SPEED
FORCE
F1
X=
0 1st
X=- 70 2nd
F2
SPEED
ON
OFF
OFFSET
QUALITY
OFFSET
Y=+230
Y=+230
QUALITY
126
7 ELECTRICAL SECTION
F3
F4
F3
F4
Advertisement
Table of Contents
