Front X Belt - GRAPHTEC FC 4500 Series Service Manual

6.26 Front X Belt

How to detach the Front X Belt
(1) Detach the Corner Cover 50L (See section 6.6.).
(2) Detach the Corner Cover B (See section 6.7.).
(3) Detach the Corner Cover 50R (See section 6.8.).
(4) Detach the Corner Cover A (See section 6.9.).
(5) Detach the Panel R (See section 6.10.).
(6) Detach the Right Side Cover (See section 6.12.).
(7) Detach the Operation Panel (See section 6.15.).
(8) Detach the Operation Tray (See section 6.16.).
(9) Loosen the M4L8 TP head screw holding the Front X Belt Tension Bracket.
(10) Loosen the two M3L8 binding head screws adjusting the Front X Belt Tension.
(11) Move the Y bar to the access hole of the M4L8 cap screw which is holding the Front X Belt Stopper
plate as shown in the picture below.
Front X Belt
Front X Belt Stopper Plate
(12) Remove the two Cap screws holding the Front X Belt Stopper plates, and then detach the Front X
Belt.
FC4500-UM-251-9370
Front X Belt
M4L8 TP head screw
Front X belt tension adjustment screw
(M3L8 binding head screw)
M4L8 cap screw
Front X Belt Tension Bracket
Front X Belt Tension Bracket
Y bar
Front X Belt Stopper Plate
There is access hole here.
50
6 REPLACEMENT PROCEDURES