GRAPHTEC FC 4500 Series Service Manual page 12

FC4510-60
(1) Pen carriage
(2) Pen holder
(3) Y bar
(4) Writing panel
(5) Control panel
(6) USB interface
(7) RS-232C serial interface
(8) AC line inlet
(9) Power switch
7
8
9
10
FC4500-UM-251-9370
: Drives the cutter/pen to the left/right.
: Holds the cutter/pen and drives it up/down.
: Holds the pen carriage; moves left/right.
: Cutting/plotting is performed here.
: Used to set and use the plotter's various functions.
: Used to connect the plotter to a computer by cable via the USB
interface.
: Used to connect the plotter to a computer by cable via the RS-232C
connector serial interface.
: Connect one end of the power cord here and the other end to an
electrical socket.
: Controls the on/off status of the power supply to the plotter.
FC4510-60
4
1
2
6
Tool holder 1 Tool holder 2
6
2 NAMES OF THE MAIN PARTS
5