Table of Contents
Advertisement
(13) Press the [F2] (ADJ.) key to display the following menu.
(14) Move the tool position to the following area of printed cross mark target by using the position keys.
(15) Press the [Enter] key. The plotter will detect the printed cross mark target with a sensor, and then
plotter draws the cross mark to the detected position.
The plotter draws this cross mark
after the Printed Cross Mark was
detected.
(16) The following menu is displayed.
(17) Measure the offset of X and Y, and then input the offset value for the X and the Y direction.
Press the [F2] key to select the X value at the above menu.
Press the [F4] key to select the Y value at the above menu.
The value can be changed by using up or down arrow keys.
Input the minus value when the drawn cross mark is shifted to the plus direction.
And you can input the factory recorded values at this times.
(18) Press the [ENTER] key after adjustment values were input.
FC4500-UM-251-9370
FORCE
F1
MOVE TO ADJ. POINT
PRESS ENTER KEY!
F2
SPEED
Move the tool position to this area.
Printed Cross Mark Target
FORCE
F1
SENSOR OFFSET ADJUST
X=0.00
F2
SPEED
OFFSET
QUALITY
Printed Cross Mark Target
OFFSET
Y=0.00mm
mm
QUALITY
106
7 ELECTRICAL SECTION
F3
F4
Offset of X direction
Offset of Y direction
F3
F4
Advertisement
Table of Contents
