GRAPHTEC FC 4500 Series Service Manual page 44

Cutting plotter
Hide thumbs Also See for FC 4500 Series:
Table of Contents

Advertisement

How to install the Pen Board
(1) Reattach the Pen Board in the reverse order in which it was detached.
(2) Move the pen block to the rear of Y bar end, and then confirm the Y Home Sensor is not touching to
the Y Home Sensor Dog.
Reposition the Pen Board if the Y Home Sensor is touching to the Y Home Sensor Dog.
Or
Bend it until it is not touching when the Y Home Sensor Dog is bending.
(3) Perform the Home Position Adjustment when the Pen Board is reinstalled (See section 7.10.). The Y
direction of Home position will be shifted a little when the Pen Board is reinstalled.
FC4500-UM-251-9370
Y Home Sensor Dog
Y Home Sensor
Pen board
38
6 REPLACEMENT PROCEDURES

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FC 4500 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Fc4500-50Fc4550-50Fc4500-60Fc4510-60

Table of Contents