Table of Contents
Advertisement
6.37 Y Slider
How to detach the Y Slider
(1) Detach the Y Rail Cover (See section 6.3.).
(2) Detach the Front Y End Cover (See section 6.4.).
(3) Detach the Rear Y End Cover (See section 6.5.).
(4) Detach the Pen Block Cover (See section 6.17.).
(5) Detach the Pen Block (See section 6.18.).
(6) Detach the Pen Board (See section 6.20.).
(7) Remove the two M3L6 binding head screws holding the Registration Mark Sensor bracket, and then
detach the Registration Mark Sensor bracket from the Y slider.
FC4500-50 / FC4500-60
FC4510-60
(8) Loosen the two M3L20 binding head screws which are adjusting the Y belt tension.
Y Belt
FC4500-UM-251-9370
M3L6 binding head screw
Registration mark sensor bracket
Registration mark sensor bracket
M3L6 binding head screw
M3L30 binding head screw
(Y belt tension adjustment screw)
68
6 REPLACEMENT PROCEDURES
Advertisement
Table of Contents
