24Vdc Stabilized Power Supply Selecting Conditions - Mitsubishi Electric M800W Series Connection And Set Up Manual

M800W/M80W Series Connection and Setup Manual
4 General Specifications

4.2.3 24VDC Stabilized Power Supply Selecting Conditions

Consider the following characteristics for the stabilized power supply, and select the power supply that complies with
laws, regulations, or safety standards of the country where the machine will be installed.
Item
Voltage
Voltage fluctuation
Current
Output
Ripple noise
Output holding time
Overcurrent output
shutoff function
CAUTION
1. Using a stabilized power supply without overcurrent protection may cause the unit's failure due to miswiring of
24V.
Specifications
When the stabilized power supply and 24VDC input unit are distant, select
24VDC the stabilized power supply which is possible to set output voltage 24VDC or
more allowing for the influence of voltage down by the cable.
±5%
Calculate the current value as a reference of maximum current consumption
-
for the unit which uses the power supply.
0.2V (P-P)
Output holding time is decided by loading ratio; however, the stabilized power
min 20ms supply which complies with the specification on the left must be selected
during maximum loading.
- Use a power supply having the overcurrent output shutoff function.
31
Remarks
IB-1501268-K