Avaya 5000 Series Troubleshooting Manual page 210

Troubleshooting layer 2 and layer 3
Figure 102: Confirm settings
Showing IP VRRP interface details
About this task
You can use the following procedure to verify critical information for the VRRP interface.
Procedure
1. At the ACLI command prompt, enter the command show ip vrrp interface
2. Review the command output to verify that
210 Troubleshooting
verbose.
• the Virtual Router is not in a hold-down state
• the corresponding VLAN is up
• the critical IP feature is enabled
• the critical IP address is set to one of the local L3 VLAN IP addresses
Comments? infodev@avaya.com
December 2013