Avaya 5000 Series Troubleshooting Manual page 148

Troubleshooting layer 2 and layer 3
Figure 70: Configuring the proxy ARP
Displaying and enabling proxy ARP using ACLI
About this task
You can use ACLI to set the Proxy ARP.
Procedure
1. Open ACLI Privileged Exec mode.
2. At the prompt, enter the show ip arp-proxy interface command.
3. At the prompt, enter the show ip arp-proxy interface [vlan
4. Open ACLI IP VLAN configuration mode.
5. To enable proxy ARP, at the prompt enter the ip arp proxy [enable]
148 Troubleshooting
<vid>]command.
command.
To disable proxy ARP, at the prompt enter the no ip arp proxy [enable]
command.
Comments? infodev@avaya.com
December 2013