Avaya 5000 Series Troubleshooting Manual page 91

Enabling allow RADIUS VLANs
About this task
Change the allow RADIUS assigned VLAN to enable.
Procedure
1. Use eapol multihost use-RADIUS-assigned-vlan command to allow the
2. Observe no errors after execution.
Showing EAPOL multihost interface
About this task
Display the EAPOL Interface.
Procedure
1. Use the show eapol multihost interface <port#> command to display
2. Note the status of ALLOW RADIUS VLANs.
Showing VLAN config control
About this task
Display the VLAN config control information.
Procedure
1. Use the show vlan config control command to display the information.
2. Identify if config control is set to strict.
Changing VLAN config from strict to flexible
About this task
Set the VLAN config control to flexible to avoid complications with strict.
Troubleshooting
use of VLAN IDs assigned by RADIUS.
the interface information.
EAP RADIUS VLAN is not being applied
December 2013 91