Avaya 5000 Series Troubleshooting Manual page 101

Enabling EAP globally and setting the port to EAP automatic
About this task
Ensure EAP globally is enabled and the port status is configured to EAP automatic.
Procedure
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to EAP
Displaying EAPOL multihost
About this task
Display the EAPOL multihost information for review.
Procedure
1. Enter the show eapol port multihost command to display the information.
2. Review the information to verify the following:
Enabling RADIUS to authenticate non-EAPOL clients
About this task
Make the required changes on the RADIUS server to authenticate Non-EAP clients.
Apply changes to RADIUS server using vendor documentation.
Troubleshooting
• The port is set to eap-auto.
automatic.
• Use RADIUS To Authenticate NonEAPOL Clients is enabled.
• Non-EAPOL RADIUS Password Attribute Format is as follows:
IpAddr.MACAddr.PortNumber
NEAP RADIUS MAC not authenticating
December 2013 101