Configuring the IP RIP interface trigger update
Before you begin
• Access the ACLI VLAN Interface configuration mode
About this task
You can use the following command to enable the trigger update for the IP RIP interface.
Procedure
At the VLAN Interface configuration mode ACLI command prompt, enter the ip rip
triggered enable command to change the update settings.
SMLT routing issue
If you experience problems with SMLT routing you must ensure that the SMLT is routing
packets properly.
Work flow: SMLT routing issue
You can use the following work flow to help determine the solution for routing issues under
SMLT.
Troubleshooting
SMLT routing issue
December 2013
193