Avaya 5000 Series Troubleshooting Manual page 125

Enabling multihost on an interface
About this task
Enable multihost processing on a specific interface.
Procedure
1. Use the eapol multihost port <port> enable command to enable
2. Verify that no error or warning messages display.
Allowing non-EAP clients on a specific interface
About this task
Enable processing for Non-EAPOL clients on a specific interface.
Procedure
1. Use the eapol multihost port <port> allow-non-eap-enabled
2. Verify that no error or warning messages display.
Modifying the maximum number of non-EAP client MAC addresses
About this task
Modify the maximum Non-EAP Client MACs to match the number of Non-EAPOL clients on
an interface.
Procedure
1. Use the eapol multihost port <port> non-eap-mac-maxcommand to
2. Verify that no error or warning message display.
Troubleshooting
• The maximum number of Non-EAP MAC addresses is configured correctly.
multihost processing on a specific interface.
command to enable Allow Non-EAPOL on a specific interface.
modify the number of allowed Non-EAPOL clients on an interface.
NEAP user policies from RADIUS not applied
December 2013 125