Avaya 5000 Series Troubleshooting Manual page 177

Procedure
1. To display the routing information, at the ACLI command prompt, enter the show
2. To view the redistribution policy, at the ACLI command prompt, enter the show ip
Showing ECMP
About this task
Use this procedure to display the number of equal cost paths that will be installed in the routing
table for the same destination.
The protocols supported are:
• Static
• RIP
• OSPF
Procedure
1. At the ACLI command prompt, enter the show ecmp to display the routing
2. Review the command output for ECMP information.
Configuring ECMP
Before you begin
• You must have an ECMP license to enable and configure EMP.
• Access the ACLI Global Configuration mode.
About this task
In order to define more routes to the same destination, with the same cost learned by RIP, you
must enable ECMP. You can define up to four routes to the same destination.
Procedure
1. At the ACLI Global Configuration command prompt, enter the rip maximum-path
Troubleshooting
ip route command.
ospf redistribute command.
information.
<number> command to configure the maximum number of ECMP paths.
OSPF route is not installed in routing table
December 2013 177