Avaya 5000 Series Troubleshooting Manual page 208

Troubleshooting layer 2 and layer 3
Procedure
1. At the ACLI command prompt, enter the command show ip vrrp interface.
2. Review the command output to verify that the admin state is UP .
Creating the VR
About this task
You can use the following procedure to create a Virtual Router.
Procedure
1. At the ACLI command prompt, enter the ip vrrp address <VR ID=1-255>
2. Review the command output for errors.
Enabling the VR
About this task
You can use the following procedure to enable a Virtual Router (VR).
Procedure
1. At the ACLI VLAN Interface configuration mode command prompt, enter the ip
2. Review the command output for errors.
Confirming that a VR is running
About this task
You can use the following procedure to verify that a VR is enabled.
Procedure
1. At the ACLI command prompt, enter the command ip vrrp.
2. Review the command output to verify at least one active link.
208 Troubleshooting
<vr ip address A.B.C.D> command to create the VR for the VLAN ID.
vrrp <1-255> enable command to enable the VR on the specified VLAN.
Comments? infodev@avaya.com
December 2013