General diagnostic tools
While in the Interface Configuration mode (also referred to as config-if mode) you can
configure parameters for each port or VLAN, such as speed, duplex mode, and rate-
limiting.
• Router configuration mode:
With the Router Configuration mode (also referred to as config-router mode) you can
configure routing parameters for RIP, OSPF, and VRRP.
Each mode provides a specific set of commands.
The command set of a higher-privilege mode is a super set of a lower-privilege mode. That is,
all lower-privilege mode commands are accessible when using a higher-privilege mode.
You can move between command modes on a limited basis. This concept is explained in the
Common Procedures section of this document.
22
Troubleshooting
Comments? infodev@avaya.com
December 2013