Configure Send And Receive - Avaya 5000 Series Troubleshooting Manual

Troubleshooting layer 2 and layer 3
Configuring a device for supply and listen
About this task
You must verify that the ports expected to send or receive RIP updates are not in an STP
blocking state.
Procedure
1. At the ACLI command prompt, enter the show ip rip interface command to
2. Review the command output to ensure that the supply and listen options are

Configure send and receive

You must verify that the RIP version configured on both sending and receiving interfaces
matches.
Task flow: Configure send and receive
You can use the following task flow to help ensure that the RIP versions match on the sending
and receiving interfaces.
182 Troubleshooting
display the IP RIP information.
enabled.
If the supply and listen options are not enabled, enter the following command:
• At the ACLI VLAN Interface Configuration mode command prompt, enter the ip
rip supply/listen enable command to enable supply and listen.
To access the VLAN Interface Configuration mode from startup
a. At the ACLI command prompt, enter enter to access the Privileged
EXEC Configuration mode.
b. At the Privileged EXEC configuration mode command prompt, enter
configuration terminal to access the Global Configuration
mode.
c. At the Global Configuration Mode command prompt, enter interface
vlan <1–4094> to access the Interface VLAN Configuration mode.
Comments? infodev@avaya.com
December 2013