Troubleshooting authentication
Setting global EAP enabled and port at eap-auto
About this task
Ensure that global EAP is enabled and the port status is configured to automatic.
Procedure
1. Use the eapol enable command to enable EAP globally.
2. Use the eapol status auto command to change port status to auto.
Showing EAPOL multihost
About this task
Display the EAPOL multihost information.
Procedure
1. Enter the show eapol multihost command to display the information.
2. Allow Non-EAPOL clients is enabled.
Allowing non-EAPOL clients
About this task
Use the command in this procedure to enable Non-EAPOL clients.
Procedure
1. Enter the eapol multihost allow-non-eap-enable command.
2. Verify that the command did not generate errors.
Showing EAPOL multihost interface
About this task
Display the EAPOL multihost interface information after you have executed the eapol
multihost allow-non-eap-enable command.
96
Troubleshooting
Comments? infodev@avaya.com
December 2013