INVT Goodrive350-19 Series Operation Manual page 168

Goodrive350-19 series VFD
P05.08 (input terminal polarity)
0
S1
1 -1
0
S2
1 -1
0
S3
1 -1
0
S4
1 -1
P05.00
(HDI input type)
0
HDIA
1 -1
0
0
1
HD1B
1 -1
This parameter is used to set the corresponding function of digital multi-function input terminals.
Note: Two different multi-function input terminals cannot be set to the same function.
Setting
0 No function
1 Forward running (FWD)
2 Reverse running (REV)
3 3-wire control/Sin
4 Forward jogging
5 Reverse jogging
6 Coast to stop
7
8 Running pause
P05.09 (digital filter time)
P05.12
T delay
P05.14
T delay
P05.16
T delay
P05.18
T delay
P05.20
T delay
P05.22
T delay
Function
Fault reset
Digital function selection
P05.13
T delay
(Default value is 1)
P05.15
T delay
(Default value is 4)
P05.17
T delay
(Default value is 7)
P05.19
T delay
(Default value is 0)
P05.21
T delay
(Default value is 0)
P05.23
T delay
(Default value is 0)
The VFD does not act even if there is signal input; you
can set the unused terminals to "no function" to avoid
misacts.
Control the forward/reverse running of the VFD by
external terminals.
Set the VFD running mode to 3-wire control mode by this
terminal. See P05.13 for details.
Frequency when jogging, see P08.06, P08.07 and
P08.08 for jogging acceleration/deceleration time.
The VFD blocks output, and the stop process of motor is
uncontrolled by the VFD. This mode is applied in cases of
large-inertia load and free stop time; its definition is the
Same as P01.08, and it is mainly used in remote control.
External fault reset function, its function is the Same as
the STOP/RST key on the keypad. This function can be
used in remote fault reset.
The VFD decelerates to stop, however, all the running
parameters are in memory state, such as PLC
parameter, wobbling frequency, and PID parameter. After
- 161 -
0
P05.01
1
2
P05.02
3
P05.03
4
Fault?
P05.04
5
.
.
P05.05
.
P05.06
.
29
30
Description
Operating
Run
P17.11
Digital input
terminal state
P07.39
Fault
Input terminal
state of present
fault