Connect The Interlock Cable - ABB HVC Installation Manual

HVC 450 kW E-Bus Charger Installation Guide
A Terminal block
B AC utility power cable
1. Move the cable towards the terminal block (A).
2. Strip 0.43 Inch of the insulation from the ends of the wires.
3. Crimp a ferrule onto the end of the wire.
4. Loosen the connector screws.
5. Insert the wires into the connectors, see table below:
Functional description
GND
L1
L2
L3
6. Tighten the connector screws.

5.8.3. Connect the Interlock cable

Interlock cable connection in the slave 2 HVC 150S:
A Terminal block
B Interlock cable from/to slave 1 HVC 150S
1. Move the cable towards the terminal block (A).
2. Strip 0.43 Inch of the insulation from the ends of the wires.
3. Crimp a ferrule onto the end of the wire.
4. Loosen the connector screws.
5. Insert the wires into the connectors, see table below:
Functional description
Interlock In (slave 1 HVC 150S)
Interlock Out (slave 1 HVC 150S)
Interlock GND
See also Appendix H Signal connection diagram.
6. Tighten the connector screws.
Revision: 1.2
Date released: 16-08-2018
Connector Wire color
X341-1 Green/yellow
X341-2 Black
X341-3 Red
X341-4 Blue
Connector
X286-4
X286-8
X286-9
Wire number
2
1
Shield
COMPANY CONFIDENTIAL
Page 74 of 128