Table of Contents
Advertisement
Electrical installation of the charge post
Procedure
1. Prepare ferrules for the wires that are
mentioned below. Refer to section 11.2.
2. Connect these wires from the power
cabinet:
8.6
Connect the Ethernet cable to the power cabinet
Preliminary requirements
Procedure
1. Guide the cable (A) to the CAN2ETH
board (B).
2. Connect the RJ45 plug to the terminal
J1 (C).
54
Wires from the power
cabinet
(A) Ground wire or shield
mesh
(B) IL IN 1
(C) IL OUT 1
(D) DC guard A1
(E) DC guard A1 RTN
Note: The colors of the cables can be different in your equipment.
The colors in the illsutration are used to clarify the explanation and to
distinguish the different cables.
•
Ethernet cable with an RJ45 plug. Refer to section
-X20
A
Connect to terminal
X20-1
X20-2
X20-3
X20-9
X20-10
1
D
B C
E
Terminal name
PE
Interlock OUT
Interlock IN
DC guard signal
DC guard GND
12.18.7
B
A
C
6AGA000032-0115-EN | 004
8
Advertisement
Table of Contents
