7.4.2
Connect the Ethernet cable
Preliminary requirements
If your EVSE has two Ethernet connections, it is possible to connect multiple EVSEs
in a chain. Only the first EVSE is connected to the PC, router or gateway. Only the
Ethernet connection is shared, there is no communication between the EVSEs.
Procedure
1. Put the RJ45 plug (A) of the Ethernet
2. Connect the Ethernet cable either to a
3. If you connect EVSEs in a chain, put
7.4.3
Insert the wires for the smart meter communication
1. Remove the grommet (A) from the
2. Install the conduit.
3. If necessary, strip the cable to the
4. Put the cable (B) through the inlet
1.
The Ethernet cable is inserted. Refer to section 7.4.1.
cable in the primary Ethernet RJ45
socket (B).
PC, router, or gateway or to the
previous EVSE in a chain (C).
the RJ45 plug of Ethernet cable to the
next EVSE (D) in the secondary
Ethernet RJ45 socket (E).
EVSE.
correct length. Refer to section 10.12.3.
hole.
Electrical installation
C
B
A
D
E
35