Move Cabinet With A Hoist - ABB HVC Installation Manual

HVC 450 kW E-Bus Charger Installation Guide
Make sure that the main switch of the power supply group for the product
is set to the OFF position. Do a voltage check to make sure that the
electrical power is disconnected from the system.
Make sure that personnel cannot be crushed or become trapped while
moving the Power Cabinet.
Warranty
Damage due to moving the Power Cabinet to its position is not covered
by the warranty.
Do not use a compressor to clean the Power Cabinet. Use a vacuum
cleaner.
1. Use one of the two options to move the Power Cabinet to the foundation.
2. When the Power Cabinet is about 19.69 Inch above its location, continue the installation
procedure with Install Power Cabinet onto the foundation on Page 57.

5.4.1. Move cabinet with a hoist

A Swivel eye bolts (standard delivered with the cabinet)
B Lifting loops
C Hoisting equipment
Preconditions:

A minimum of two persons is required: one person to operate the hoisting equipment,
the other person to guide the Power Cabinet to its location.

Use M16 swivel eye bolts (A) or M16 bolts with lifting loops (B).
Revision: 1.2
Date released: 16-08-2018
DANGER
WARNING
CAUTION
CAUTION
COMPANY CONFIDENTIAL
Page 55 of 128