External Battery Charger - GE Voluson i BT06 Service Manual

GE
D KTI106052, R
IRECTION
3-6-4-1-2

External Battery Charger

NOTE: The
fuel gauge when detected to be out of calibration. The charger is specifically designed to operate
with the Voluson i / Voluson e smart-battery.
Always observe the following SAFETY precautions:
CAUTION
• Do not use in patient environment!
!! CAUTION:
• Do not use in anesthetic and oxygen patient environment!
• Do not expose the charger or power supply to water or conductive liquids (this is not a sealed case).
• Do not open the charger or power supply case. There are no user-serviceable parts inside.
• Do not cover the fan exhaust or obstruct the airflow, as this will cause overheating.
• Use only the manufacturer's power supply and observe terminal polarity.
• Place the charger in a cool location, away from external heat sources.
• CAUTION: During recalibration, the battery connector and base of the charger may become warm.
1.) Place the charger unit on a flat, level surface away from sources of heat and moisture.
2.) Plug the DC connector from the power supply into the back of the charger.
Status Window
3.) Connect the power supply to the mains AC supply, using the cable supplied.
4.) Place the battery into the battery bay making sure that the connector is fully seated.
The LEDs in the status window (see
Table 3-11 on page
During the charging procedure, the green LED is flashing.
At the end of this procedure, when the battery is fully charged, the solid green LED is illuminated in
the status window, indicating a fully charged battery.
10
EVISION
is a stand-alone desktop smart-battery charger with the added ability to recalibrate the
CH5000
Figure 3-92 Battery Charger Unit
3-73, and the charger will automatically starts charging.
Chapter 3 - Setup Instructions
Calibration Button
Figure 3-92, above) provide status information as detailed in
V i / V
OLUSON OLUSON
S M
ERVICE ANUAL
Battery Bay
DC Connector
e
3-75