Voluson I / Voluson E Mounted On Dock Cart - GE Voluson i BT06 Service Manual

GE
D KTI106052, R
IRECTION
3-5-13-2 Voluson i / Voluson e mounted on Modo Cart
NOTE: For instructions see:
The VCR must be powered from the Modo Cart itself, via one of the isolated peripheral power cables
provided on the Modo Cart. The video signal is received through a VGA-to-video converter, and this
must also be powered through one of the peripheral power outlets available on the Modo Cart.
1.) Connect one end of the VGA cable to SVGA OUT located on the Voluson i / Voluson e rear
connector panel.
2.) Connect the other end of the VGA cable to RGB IN on the video converter (rear).
3.) Connect one end of the S-Video cable to S-VIDEO OUT on the video converter.
4.) Connect the other end of the S-Video cable to S-VIDEO IN at the rear of the VCR.
NOTE: Dip switches are located beneath the video converter, as shown in
5.) Set the switches to the correct positions, as shown in
6.) When all power and signal cables are connected to the system, VCR, and video converter, proceed
as follows (in the order stated):
a.) Press the power ON switch on the VCR.
b.) Press the power ON switch on the video converter.
c.) Turn ON power to the Voluson i / Voluson e system.
7.) Press the Input Select button (see
in order to select RGB Input as your signal source.
The LED located on the video converter front panel will be illuminated, accordingly.
3-5-13-3

Voluson i / Voluson e mounted on Dock Cart

NOTE: For instructions see:
The VCR must be powered from the Dock Cart itself, via one of the isolated peripheral power cables
provided on the Dock Cart. The video signal is received through a VGA-to-video converter, and this
must also be powered through one of the peripheral power outlets available on the Dock Cart.
1.) Connect one end of the VGA cable to SVGA OUT located on the Voluson i / Voluson e rear
connector panel.
2.) Connect the other end of the VGA cable to RGB IN on the video converter (rear).
3.) Connect one end of the S-Video cable to S-VIDEO OUT on the video converter.
4.) Connect the other end of the S-Video cable to S-VIDEO IN at the rear of the VCR.
NOTE: Dip switches are located beneath the video converter, as shown in
5.) Set the switches to the correct positions, as shown in
6.) When all power and signal cables are connected to the system, VCR, and video converter, proceed
as follows (in the order stated):
a.) Press the power ON switch on the VCR.
b.) Press the power ON switch on the video converter.
c.) Turn ON power to the Voluson i / Voluson e system.
Press the Input Select button (see
order to select RGB Input as your signal source.
The LED located on the video converter front panel will be illuminated, accordingly.
3-58
10
EVISION
Section 3-5-1-3 "Mounting large Peripherals (e.g., Color Printer)" on page
Section 3-5-2-6 "Mounting large Peripherals (e.g., Color Printer)" on page
Section 3-5 - Connection of Auxiliary Devices
Figure 3-72 on page
Figure 3-71 on page
Figure 3-72 on page
Figure 3-71 on page 3-57) on the video converter three times in
V
OLUSON
Figure 3-71 on page
3-57.
3-57) on the video converter three times
Figure 3-71 on page
3-57.
i / V e
OLUSON
S M
ERVICE ANUAL
3-28.
3-57.
3-34.
3-57.