Led Diagnose Patterns - GE Voluson i BT06 Service Manual

GE
D KTI106052, R
IRECTION
7-3-2

LED diagnose patterns

If an error condition will be recognized by the Power Management Controller SW, it will indicate the error
by a special blinking code using the 2 power status leds (see
The normal led indication will be interrupted every 20 seconds for a second of fast blinking, following
with 0.5 second of black state and then the appropriate error code pattern,defined
Table 7-5
will return to the normal indication of the system state. Usually the GPP and GPC are ordered.
Table 7-4
AC Adapter
LED Status
Green
Green
Green
Table 7-5
AC Adapter
LED Status
Orange
Orange
Orange
10
EVISION
below. The pattern will be followed by another 0.5 second of black state, and then the leds
Errors from the power source
Battery
LED Status
once
Green
flashing
twice
Green
flashing
three
times
Green
flashing
other Errors
Battery
LED Status
once
Orange
flashing
twice
Orange
flashing
three times
Orange
flashing
Chapter 7 - Diagnostics/Troubleshooting
Errors
PWR_OK_FAILURE
STDBY_5V_FAILURE
BE_PWR_GOOD_FAILURE
Errors
BE_PS_ON_FAILURE
BE_PCI_CLK_FAILURE
FE_PWR_ON_FAILURE
V
OLUSON
Figure 7-3 on page
1st Action
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
1st Action
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
1. disconnect Power Supply cable
2. remove battery pack
3. wait 1 minute
4. reinsert battery pack
5. connect the Power Supply cable
6. restart the system
i / V e
OLUSON
S M
ERVICE ANUAL
7-6).
Table 7-4 and
2nd Action
1. replace GPP
2. replace battery
pack
replace GPP
1. replace GPC
2. replace GPP
2nd Action
replace GPP
replace GPC
replace GPP
7-7