Table of Contents
Advertisement
GE
D
KTI106052, R
IRECTION
10-7-11
Probe Leakage Current Test
Do not use the probe if the insulating material has been punctured or otherwise
DANGER
compromised. Integrity of the insulation material and patient safety can be
verified by safety testing according to IEC60601-1.
10-7-11-1
Definition
This test measures the current that would flow to ground from any of the probes through a patient who
is being scanned and becomes grounded by touching some other grounded surface.
NOTE:
Some leakage current is expected on each probe, depending on its design. Small variations in probe
leakage currents are normal from probe to probe. Other variations will result from differences in line
voltage and test lead placement. It is abnormal if no leakage current is measured.
If no leakage current is detected, check the configuration of the test equipment.
10-7-11-2
Tools
For needed tools, see:
10-7-11-3
Generic Procedure on Probe Leakage Current
The most common method of measuring probe leakage is to partly immerse the probe into a saline bath
while the probe is connected to the ultrasound system and active.
This method measures the actual leakage current resulting from the transducer RF drive.
Measurements should be made under the test conditions specified in:
•
Table 10-10 on page
•
Table 10-11 on page
For each combination, the probe must be active to find the worst case condition.
POWER
OUTLET
NOTE:
Each probe will have some amount of leakage current, dependent on its design. Small variations in
probe leakage currents are normal from probe to probe. Other variations will result from differences in
line voltage and test lead placement.
10
EVISION
Section 10-4 "Tools Required" on page 10-5
10-13, or:
10-13, as applicable.
POLARITY REVERSING SWITCH
H (BLACK)
N (WHITE)
G (GREEN)
MOMENTARY
SWITCH
Figure 10-7 Set Up for Probe Leakage Current
Chapter 10 - Care & Maintenance
V
i / V
OLUSON
S
ERVICE
PROBE
CONSOLE
LEAKAGE TEST
METER
e
OLUSON
M
ANUAL
10-23
Advertisement
Table of Contents
Troubleshooting
