GE Voluson i BT06 Service Manual page 362

GE
D KTI106052, R
IRECTION
System Software - Installation Procedure (FMI from external device) (cont'd)
8-2-2-5
19.)The system is rebooting into windows (Boot screen - Voluson).
20.)Please wait until all processes are finished. Finally the 2D screen is displayed on the monitor.
NOTE: If the BT warning dialog
(refer to
enter "Permanent key"
then click [Submit]
21.)Remove the Stick from the USB port on the rear of the system.
22.)Reconnect the external devices, install all the printers and adjust the printer settings as described
in Section 3-7 "Printer Installation" on page
23.)Check and match system settings in the
24.)Confirm that the date and time are set correctly and that the Windows automatic DST feature is off.
Refer to
8-20
10
EVISION
Figure 8-26 automatic processes are running
(Figure 8-27
Figure 8-17: Option page (e.g., Voluson i) on page
Figure 8-27 Enter Permanent key
Section Section 6-10 "Daylight Saving Time (DST) - New Dates" on page
Section 8-2 - System Software - Installation/Upgrade Procedure
below) appears, enter the Permanent key previously recorded
8-15) and then click SUBMIT.
3-80.
page´s [Print], [Save] and [Export] tab.
P1-P2-P3
V i / V e
OLUSON OLUSON
S M
ERVICE ANUAL
6-12.